LED bulbs H7 GT K5 | modern ZES diodes | 16000 lm 80W 12V-24V CAN BUS

A set of LED bulbs for low / high beam

Due to the high efficiency of the LEDs in this set, we recommend its use as:

• dipped beam (low beam) bulbs
• bulbs for high beam (high beam)

Active cooling consists in reducing the height of the air temperature with the help of a fan . The advantage of this solution is a much higher cooling capacity than in the case of passive cooling (without fan).

The GT K5 LED bulb housing is made of high-quality, highly thermally conductive aluminum ( Aviation aluminum 6063 )

Technical Specifications:

• Model: A set of LED bulbs H7 GT K5 80W ZES 16000lm
• Number of LED bulbs: 2
• Number of LEDs: 6 / bulb
• Light intensity: 16,000 lm
• Total power consumption: 2x 40W
• Splashproof: IP67
• Supply voltage: 12V - 24V
• Light color: snow white 6500k
• Lamp replacement: H7, H7R, H7M
• CE, RoHS certification

The bulbs have built-in CAN-BUS filters, so they will not cause errors on the on-board computer.

H7 GT K5 LED bulbs are equipped with a removable bulb collar , which greatly facilitates the installation of bulbs in lamps that are difficult to access.

Precise, multi-stage adjustment of the collar allows you to adjust the angle of incidence of light on the reflector and the road.

Bulb Efficiency: Low beam (left photo) and high beam (right side)

Thanks to the optimal geometry and arrangement of the LED diodes, they allow you to set the required light-shadow cut-off line.

H7 GT K5 bulbs emit light to the road in a very precise way, achieving an unprecedented brightness, while maintaining a snow-white color of the light.

The kit includes:

• Two H7 GT K5 LED bulbs
• Pictorial assembly instructions
• Packaging (perfect for a gift)

H7 LED bulb installation guide:

Step 1-2 : Detach the plate holding the bulb in the H7 socket and remove the old bulb.

Step 3 : Remove the adapter from the H7 LED bulb. We put it in the place of the bulb, and then fasten the mounting plate.

Step 4 : Insert the bulb into the previously fastened adapter. We connect the bulb to the H7 cube. The light bulb power cord with the H7 cube is best placed inside the lamp, between the housing and the reflector. The bulb can be rotated 360 ° in order to find the appropriate angle of incidence of light on the illuminated area in front of the vehicle.

Step 5 : Put a cover on the housing to protect the inside of the lamp against moisture.

Despite the small space in the tested lamp (Fiat Punto II), after installing the H7 LED, it was possible to close the cover and seal the inside of the lamp. Before buying, we recommend that you check whether the target lamp has a spare space between the bulb's collar and the cover. In our lamp, the distance between the bulb and the edge of the housing on which the cover is inserted is 32 mm.